I believe everyone is familiar with the human-machine interface. We use many terminal self-service equipment in our daily work and life, such as bank teller machines, self-service vending machines in scenic spots, self-service ticket machines at stations, etc. These human-machine interface terminals are used All of them are embedded all-in-ones. If a fault occurs, it will have a great impact on the work. Then, what are the ways to deal with the faults of the human-machine interface of the embedded industrial all-in-one? Let's first understand what are the faults.
1. The man-machine interface does not respond, and there is no response when touching any part.
Solution: In this case, first check whether each wiring interface is loose, and then check whether there is a conflict between the serial port and the interrupt number. If it is caused by a conflict, you should adjust the resources to avoid the conflict.
Secondly, check whether there are cracks on the surface of the man-machine interface. If cracks are found, they should be replaced in time. In addition, it is necessary to check whether there is dirt on the surface of the man-machine interface. If there is, use a soft cloth to remove it. Observe and check whether the indicator light on the control box is working properly. When it is normal, the indicator light is green and flashing.
If the above parts are normal, you can use the replacement method to check the man-machine interface, first replace the control box, then replace the touch screen, and finally replace the host.
2. The man-machine interface is normal but the computer cannot be operated. A man-machine interface has been tested and everything is normal, but the computer cannot be operated after it is connected to the host.
Solution: In this case, there are two reasons. First, it may be that the man-machine interface driver version is too low, and the latest driver needs to be installed. Second, it may be that before the host starts to load the man-machine interface driver, the man-machine interface control card receives the operation signal, and only needs to restart the computer after the power is turned off.
3. Inaccurate touch. A surface acoustic wave man-machine interface, touching the part of the display screen with a finger cannot normally complete the corresponding operation.
Solution: There are two reasons for this phenomenon. The first possibility is that the reflective stripes of the sonic screen are slightly damaged. If this happens, it will not be completely repaired; the second possibility is that the reflective stripes around the screen are covered by dust after the sonic man-machine interface has been used for a period of time. , Can be wiped with a dry soft cloth, then power off, restart the computer and recalibrate.

